Eco Pure EP 7130, Installation And Operation Manual

Page: 13 / 27

13
SET RECHARGE (REGENERATION) TIME
1 . Press the SELECT / MENU button once again to
display a flashing “2:00AM” and the words “SET
RECHARGE TIME”. This is a good time for the
recharge to start in most households, because
water is not in use.
2 . If you want to change the recharge start time,
press the
r
UP or
s
DOWN buttons until the
desired time shows. Be sure AM or PM is correct.
FIG. 18
FIG. 19
Programming the Water Softener
SET SALT LEVEL
The water softener has a low salt indicator light to
remind you to refill the storage tank with salt.
NOTE: You must set salt level each time salt is added
to the water softener.
To set this monitor system:
1 . Slide open the salt lid and level the salt in the stor-
age tank.
2 . The salt level decal, on the brinewell inside the
tank, has numbers from 0 to 8. Observe the high-
est number the leveled salt is at, or closest to.
3 . Press the SELECT / MENU button to display a
flashing “OFF” and the words “SET SALT LEVEL”.
4 . Press the
r
UP button until the number on the
screen corresponds to the salt level. At level 2 or
below, the “Low Salt" LED indicator will flash. If
you wish to turn this feature off, press the
s
DOWN button past 0, and the word “OFF” flashes
in the display.
5 . Press the SELECT / MENU button once more to
complete the initial programming. The current time
of day will show in the display.
FIG. 20