−−
JAPANESE
GERMAN
FRENCH
ITALIAN
SPANISH
ENGLISH
- Adjusting the angle of the speaker -
Loosen the guide screw and tilt the speaker to the
desired angle.
1
Once you have determined the angle, tighten the guide
screw to secure the speaker.
2
- Installing the caps and protective net -
Attach the caps in five places as shown in the
illustration.
1
･
The angle of the speaker is 0° when the stand pins are at
position
Ⓐ
, and is 12° when the stand pins are at position
Ⓑ
.
･
Support the speaker with your hand when tightening the
guide screw.
Tip
Speaker
Loosen
- Adjusting the spikes -
Turn the spikes to adjust as shown in the illustration.
1
･
Turn the four spikes all the way counterclockwise before
placing the stand on the floor.
･
Turn the spikes clockwise one by one. When you feel
the ends of the spikes touching the tray, stop turning the
spike at that point. (Adjustment range is 10 mm.)
Tip
Spike
Install the protective net.
2
･
The protective net may be attached when the speaker is
not in use or at the users discretion.
･
If the protective net comes off the net ring, fit the
protective net back into the groove in the net ring.
Tip
Protective net
Cap
Upward adjustment
Net ring
Groove
Pin positions
Base of speaker
Guide screw
Tighten
