- 19 -
ENGLISH
■
Care
Before attending to the care of the amplifier,
be sure to turn the power OFF and remove
the power cable plug from the power outlet.
Remove any soiling on the product by wiping
lightly with a soft cloth.
If the soiling is severe, wet the cloth with
water, wring it out well, wipe the soiling off,
and then finish with a dry cloth.
Do not wipe the product with benzene or any
thinner.
This could damage the surface of the cabinet.
■
If the amplifier operates abnormally
If, during use, the amplifier is subjected to
strong external noise (abnormal power supply
voltage caused by excessive impact, static
electricity, or a lightning strike), or it is handled
incorrectly, it may stop operating correctly.
If this happens, turn the POWER switch
“OFF”.
Upon turning the power back ON, check that
operation is normal.
(If the fault remains, please contact Fujitsu
Ten.)
■
Notice for WEEE directive
In accordance with the WEEE directive,
whenever this product is sold in member
states of the EU after August 13, 2005 it must
mandatorily bear the WEEE mark.
When disposing of this product in an EU
member state, do so in accordance with the
laws of that state, for example by returning it
to the distributor.
※
WEEE : Waste Electrical and Electronic
Equipment.
Thinner
Benzene
■
Specifications
Please note that the specifications and
external appearance of the amplifier are
subject to change without notice for the sake
of improvement.
[Amplifier section]
Rated output : 12 W
(Load 8
, THD: At 1%)
Max. output : 15 W
(Load 8
, THD: At 10%)
Output type
: BLT output
Total high frequency distortion factor :
0.05% (At 1 W output: 1 kHz)
Frequency characteristic : 10 Hz to 100 kHz
(+/-3 dB)
Input sensitivity : 180 mVrms
(At 12 W output)
Signal/noise ratio : 85 dB
Degree of separation : 50 dB
Input impedance : 10 k
Compatible load impedance : 8
Outside dimensions :
W 159 x D 137 x H 154 (mm)
Weight
: 930g
[AC adaptor]
Input voltage : 100 VAC (Japan)
120 VAC (North America)
230 VAC (Europe)
Output voltage : +17 VDC
Output curren : 2.9 ADC
Outside dimensions:
W 121 x D 56 x H 33 (mm)
Weight
: 360 g
Care and Specifications