5.6 Battery Troubleshooting
Battery voltage is too low after being fully charged
.
Solution:
Contact your installer or distributor.
Battery is in long-term storage with no use and is not being maintained properly.
Solution:
Please test the battery voltage. If the battery voltage is <30V, it can't be
charged and needs to be un-wired and isolated. Please consult your installer or
distributor. If the voltage is ≥30V, the battery can be isolated to its' own charger
and checked to see if it can be charged normally.
Battery Disconnection
Solution:
Battery is powered but no voltage is present. Contact your installer or
distributor.
Battery has suffered a collision and has damage to the case or has an electrolyte
odor.
Solution:
It’s not in the end user to repair a damaged battery. Contact your installer
or distributor.
Insufcient capacity
Solution:
Charge fully and discharge to 50% SOC the battery with 3~5 cycles.
Battery voltage is not stable or the battery cannot charge or discharge normally.
Connectors or terminals not making good contact
Solution:
Clean or replace the connectors.
6.PRODUCTS DISCLAIMER
Before using the battery, please read the specications, usage/ maintenance instructions
and pay careful attention. Suppliers are not responsible for any incident caused by not
installing and operating the battery according to this manual. Any problems from incorrect
use, installation, connection, or input/output power, inconsistent with this manual, may
cause damage to product. Improper use or installation can lead to battery damage and
possible damage to the structure the battery is housed and cause injury.
The manufacturer and distributors are not responsible for incorrectly
installed or used batteries. The manufacturer or distributors are not
responsible for damage to equipment from improper use or installation
of these batteries.
Page 9 of 9
Solution:
Contact your installer or distributor.
Any other problems not described in this manual.
Solution:
Contact your installer or distributor.
