Eclipse CD7000, Owner'S Manual

Page: 49 / 327

ESN security operating procedure
49
VIII
[MS] will appear on the display. If you
press the [MODE] button once more,
the display will return to [----] (security
code entry display).
ATTENTION
If a Memory Stick has already been inserted, a
[MS EJECT] message appears. In this case,
eject the Memory Stick and insert again. (Refer
to "Ejecting Memory Stick" on page 36 for
details on ejection of the Memory Stick.)
The recorded data will be read from
the Memory Stick.
ATTENTION
• If the contents recorded in the Memory Stick
do not match the information recorded by
the main unit, [ERR_] (ERR and the error
number) will appear on the display for two
seconds, and then [- - - -] (security code
entry display) will appear. If this happens,
check the Memory Stick and repeat the
procedure from step 2.
• If [ERR5] (the 5th time an error has
occurred) appears, [HELP] will appear.
When [HELP] appears, carry out the
operations for an ESN security lock out by
following the procedure in "What happens if
a Memory Stick or security code is
incorrect?" on page 49.
• ESN security lock cannot be canceled by
this procedure if the Memory Stick
containing the security code was formatted.
What happens if a Memory Stick or
security code is incorrect?
After the [HELP] message was
displayed for five seconds, serial
number will appear. You will only get 5
unsuccessful unlock code entries.
After the 5th attempt, you will be asked
to insert the DISC (Key CD). At this
point, please contact your local Eclipse
dealer or Eclipse Customer Service for
procedure on unlocking the main unit.
How to operate the ACC
security
ACC security involves using Memory Stick
security to record a security code, and then when
the ignition switch is turned to OFF and back to
ACC, the operation of all buttons is disabled.
2
Press the [MODE] button.
3
Insert the Memory Stick that has
been recorded, and then close the
front panel.
4
If the contents recorded in the
Memory Stick match the
information recorded by the main
unit, [OK] will appear on the
display for two seconds, and then
the main unit will return to normal
operation.
1
After the 5th incorrect attempt, the
display reads [HELP] for five
seconds.
Your security code and Memory Stick
can be easily forgotten. Write the
security code and Memory Stick title in
a reminder note (See page 109).
1
Check that the main unit is in
standby.