ESN security operating procedure
31
VII
What happens if an incorrect CD is
inserted?
After the [HELP] message will appear
for five seconds, serial number will
appear.
After the [SEC] message appears for
two seconds, rolling code (six digit) will
appear.
[DISC] flashes on the display.
You will have five more attempts to
insert correct disc.
If the correct CD is inserted, an [OK]
message will appear for two seconds
and the CD will be ejected.
ATTENTION
• If an incorrect CD is inserted, an [ERR_ ] ("ERR"
and error number) message will appear for two
seconds, after which the CD will be ejected.
• This process cancels the protection for ESN
equipment.
How to turn the security
indicator on/off
Once ESN security is activated, the indicator
flashes whenever the vehicle's ignition switch is
turned off, warning potential thieves that the
equipment is protected. However, if do not want
this visible deterrent, it may be turned off.
[IND. FLASH] means the security
indicator will flash when the vehicle's
ignition switch is off, and [IND.-----]
means it will not. Repeat the above
steps to reactivate the flash mode.
How to read the Electronic
Serial Number
[ESN] appears on the display, followed
by an eight-digit number; this number
is your electronic serial number (ESN).
You may use this number to identify
your Eclipse CD3000 in the event of
theft recovery.
1
After the 5th incorrect attempt, the
display reads [HELP] for five
seconds.
2
Press the [CD
] button to close
the front panel.
3
Press the [FUNC] button, then the
button [6], and hold them for five
seconds.
4
Press the [FUNC] button.
5
Insert the Key CD into the slot.
●
Note
●
If after 5 tries the correct Key CD is not
inserted, the display will read [CALL]; the
equipment must be returned to Eclipse to
be reset. In this case, please contact your
Eclipse dealer for assistance.
Your Key CD can be easily forgotten.
Write the album name in a reminder
note (See page 63).
1
With the equipment in standby,
press the [FUNC] button, then the
button [2] and hold both for more
than one second.
2
[IND. FLASH] or [IND.-----] appears
on the display.
1
Check that the equipment is in
standby.
2
Press and hold the [FUNC] button,
then the button [4], and hold both
for more than one second.
