- 7 -
１．
Slip the post onto the tripod (large) and fasten
with screws having attached washers (M4 x
10mm).
（
2
）
Assemble post and tripod (large)
Tripod (Large)
Post
Screws with
attached washer
(M4 × 12mm) × 2
FRONT
１．
Slip the joint onto the 307 speaker and fasten
with washer, spring washer and nut.
２．
Insert the joint now attached to the 307 speaker
into the post, and then fasten with the screw
having an attached washer (M3 x 6mm).
（
3
）
Install 307 speaker onto post
307 Speaker
Tripod (Large)
FRONT
Post
Screw with
attached washer
(M3 × 6mm)
Washer
Nut
Joint
・
The speaker is heavy, so use both hands
when lifting to slip it onto the post.
・
Be careful not to mix up the tripod fixing
screws with washers (M4 x 12 mm) and
the joint fixing screws with washers (M3 x
6 mm) during assembly.
・
If you tighten the nuts (marked with
※
)
while the speaker screws (marked with
★
)
are at an angle, the speaker will remain
loose and will not be secure . If this
happens, loosen the nuts (marked with
※
), check that the speaker screws (marked
with
★
) are straight, and then carefully
retighten the nuts (marked with
※
).
Caution
Assemble stand so that the "ECLIPSE TD"
logo in on the right side when seen from the
front.
Caution
"ECLIPSE TD"
Logo
"ECLIPSE TD"
Logo
Spring Washer
Speaker
screw
★
※
