9
4.2
NETWORK REQUIREMENTS AND CONFIGURATION
VEO-XTI1CG2 and VEO-XRI1CG2 are not limited to certain brands of network hardware,
but the
network must support the following network features
:
•
Type of layer 3 managed network switch.
•
Support and enable IGMP snooping and the adequate multicast filtering.
To
prevent malfunctioning, interference or drop in signal performance
due to other
network products bandwidth requirements or network design. It is highly recommended to
check with the chosen network IT staff how to properly set the Multicast products
connected to the local network switch.
4.2.1
SETTING THE IP ADDRESS
The default IP address for transmitters and receivers is “auto IP” in the range 169.254.x.x
or it is dynamically assigned by the VEO-XCTRLG2 controller in case it is present in the
network. For further details please refer to VEO-XCTRLG2 controller module user manual.
•
It’s possible to
check the assigned IP address
from a transmitter or receiver
pressing
and holding the
▲
(UP button) on the front panel
. For further details, refer to
Additional functionalities of CH select
buttons for both: VEO-XTI1CG2 & VEO-
•
The IP address can be changed using the embedded web page of transmitter and
receiver
. Both the network configuration of PC and VEO devices must be in the same
network domain in order to be able to access its web settings page through an
internet browser. For further details, refer to
Configuration using Web interface
When static IP addresses are required, the IP address of each device needs to be
set manually.
