Ecler MIM088SG, User Manual, Page: 6 / 33

6
o
Routing matrix/mixer, from any input to any output with adjustable level
for crossover points (independent mixes of different inputs for each
output).
o
Mono or stereo channel processing.
o
Level control, mute, vu-meters and phase adjustment for inputs and
outputs.
o
Internal signal generator (sine wave, pink noise, white noise, polarity test).
o
Parametric EQ on inputs and outputs.
o
Delay on inputs and outputs.
o
Gate/compressor on input channels.
o
Compressor/limiter on outputs.
o
Input channel priority assignment ( ducking ).
o
Virtual and physical messaging consoles ( paging ).
o
Standard MIMO88SG / MIMO1212SG firmware version (for generic use)
and alternative version, for conferencing applications (MIMO88SG /
MIMO1212SG CONFERENCE version). Both firmware versions are
compatible with the MIMO88SG / MIMO1212SG hardware which can be
freely updated with anyone of them.
The MIMO SG programming is done with EclerNet Manager . Please refer to EclerNet
Manager Software manual at www.ecler.com for more information.
INSTALLATION
5.1. Location, assembly, ventilation
MIMO SG series has been especially designed to be installed in a standard 19" rack,
taking up 1U.
It is very important not to enclose the MIMO SG or expose it to extreme temperatures as
it generates heat. It’s also necessary to promote the passage of fresh air through the
ventilation holes of the chassis, leaving at least one rack unit off between each device
and installed above and below it in the rack frame.
If the setup has several amplifiers in the same rack or in a closed cabinet with doors, it is
highly recommended to supply them forced ventilation, installing fans at the upper and
lower ends. This upward air flow will help to dissipate the heat generated inside.