ECLAIR ACL I Camera, Manual

Page: 16 / 25

FIG. 10. CHARGER WITH BATTERY IN POSITION.
3.5. THE CHARGER
This is fitted in a plastic case and supplied with
suitable cable. It operates from mains supplies.
There is an automatic cut out at full charge. A safety
fuse (0.8 amp) has been inserted Into the circuit for
protection against overload. Spare fuses are kept
under the two chrome studs in the base of the
charger.
3.6 ACCESSORIES
Transport Case (Code MIKOF) of aluminium alloy
with non-absorbent foam lining contoured to accom-
modate ACL complete with magazine and zoom lens
ready for use, 2 spare magazines, 2 batteries, rapid
charger, leads and other small accessories. Its
(hammered) finish gives a lasting new appearance
and is strong enough to stand on. Fitted with a dust/
damp
proof seal between hinged lid and base. The dimen-
sions are 565mm (221/41n) x 210mm (81/4in) x
350mm 0 3%in).
Crystals. Two crystals are available. These have
fundamental frequencies of 1024 kHz and 983.04
kHz for 25 f.p.s. (code MIQBI) and 24 f.ps. (code
MIQUA) respectively. Each crystal is moulded to a
block engraved with the corresponding camera
speed and is attached by means of a “penny slot”
screw to the side of the motor case. Electrical con-
nection is via a miniature two pin connector. The
accuracy is guaranteed to be _ 50 p.p.m.
over a temperature range of -20˚C to +65˚C (-4˚F to
+149˚F). This is equivalent to less than 1/2 frame in
60m
(200ft) of film.
15