Eckstein Keyestudio
11
4)
Use Method
1. AT Command Settings
When setting the AT command, you need to use an
Plug the ESP8266 WIFI onto the shield, and then connect them to your computer
’
s USB
port using a mini USB cable. Then push the shield
’
s button to
Flash Boot
end.
Connected successfully, open the
, set the baud rate to 115200,
click to open the Serial Port, and click Test the AT.
You should see the data received window will print out
AT OK
.
To set other AT commands, the method is similar.
You can download the ESP8266 debugging tool from the link below:
https://drive.google.com/open?id=1TS56giNcC3Jd98Rg1mNyWyq13ePnZeyQ