ECKELMANN VS 300, Operating Instructions Manual

Page: 100 / 172

Operation of VS 300
92 Doku-Version 2.05 - Firmware 2.10 - 15. September 2017
7.16 Remote control via a terminal
Further details for the operation of a system centre, store computer or operator terminal can be
found in their operating manuals.
For the remote control of a controller, it makes no difference whether this is done with a system centre (A), a
store computer or with an operator terminal (B) as the user interfaces on the terminals are almost identical and
the same functions are available. See chapter 7.3.2 for details about remote control.
The system centre only emulates the "hardware front" of its "store computer" predecessor or of the operator ter­
minal by software on its touchscreen which is demonstrated by the following comparison between the terminals
of the CI 4x00 and CI 3x00 / AL 300:
MODE ESC
PR I O 1
PR I O 2
,
9
WXY Z
7
P Q RS
8
T UV
6
MNO
4
GH I
5
J KL
3
DEF
2
ABC
1
0
ALARM
RESE T
(1)
( ) 8
( ) 10 ( ) 9
( ) 7 ( ) 3 ( ) 6
Z
N
R
.
21003
DEF
01
CI 4000
TOUCH
( ) 4
( ) 2
( ) 5
A
B
( ) 1 ( ) 2
( ) 8 ( ) 7 ( ) 5 ( ) 6 ( ) 4 ( ) 3
(1) CI 4x00: "Alarms and messages" button in the main menu for display of whether alarms are
pending.
Alarms are acknowledged in the "alarm list".
CI 3x00 / AL 300: Red LED signal lamps to indicate whether alarms are pending.
(2) CI 4x00: "Horn" button in the main menu for muting of the buzzer and
for reset of the AUX relay.
CI 3x00 / AL 300: Button for muting of the buzzer,
for reset of the AUX relay* and for acknowledgement of alarms.
(3) Display (4 lines x 20 characters) for display of the menu of the controller.
(4) ESC button
(5) Cursor buttons
(6) MODE button for, e.g. toggle upper case / lower case for text input.
(7) Alphanumeric keypad
(8) ENTER button (
↵
)
Only CI 3x00 / AL 300:
(9) On/Off button for, e.g. lighting
(10) Green LED signal lamp for status indicator whether the button is activated (then green) or deactivated.