Firmware V6.6.9
29.07.2020
9/147
•
•
•
•
•
•
•
•
•
•
2 Safety Information
This operating manual is part of the device. It
must
be kept in the vicinity of the controller as well as for
future use so that it can be consulted when required. The operating manual must be available for the
operating and maintenance personnel
at any time
for the avoidance of operating errors, see chapter
Requirements for the personnel
.
For safety reasons, the equipment must not be used for any applications other than described in the
operating manual and only for the intended use, see chapter
.
Before using the device, check whether it is suitable for your application with regard to its limit values.
Note the maximum load of the relay contacts, see chapter
Specifications of System Centre and SIOX
Before connecting the device, it must be checked whether the power supply is suitable for the device.
When using uncoded plug connectors, it is possible to connect them so that there is a danger to life and
limb! If this cannot be ruled out, coded plug connectors must be used.
Specified environmental conditions (e.g. humidity and temperature limits) must be observed and complied
with. Otherwise, malfunctions are possible (see chapter
Specifications of System Centre and SIOX
.
Before switching on the device, check correct wiring of the connections.
Opening the device is not authorised!
Contact the supplier in the case of any malfunction.
The safety regulations, instructions and information described in this chapter must be strictly observed
and complied with. During repairs on the entire E*LDS system, the accident prevention regulations and
general safety regulations must be strictly complied with. Important information (safety instructions and
hazard warnings) are indicated by appropriate symbols (see chapter
. Follow these
instructions in order to prevent accidents and danger to life and limb, as well as damage to the E*LDS
system.
Warning about dangerous electrical voltage! Danger of electric shock!
Beware of external voltage
at the digital inputs and outputs! All device connections/male connectors must only be plugged in,
unplugged and/or wired when
no voltage is present
.
1. According to experience, transmission of alarms is not yet functional during commissioning (no
telephone line laid etc.). It is strongly recommended in such cases to monitor the controller via the
CAN bus using a system centre or an operator terminal and to enable transmission of alarms using a
GSM modem via a mobile telephone system. In standalone operation, or as an alternative to
monitoring with system centre / operator terminal, an available alarm contact on the controller must be
used to realise transmission of alarms via a telephone network.
2. After the setting up of transmission of alarms or alarm signalling, this must be tested and checked
for its function.
For further information about the CAN bus, see the operating instruction "Basics and General Safety
and Connection Notes".
•
•
•
•
•
•
Work on the electrical system may
only be performed by authorised specialist personnel
(according to the definition for specialists in DIN/VDE 0105 and IEC364, see
) and in accordance with the respective applicable
VDE regulations
Local safety regulations
Intended use
Five safety rules according to BGV A3
ESD measures
Operating instructions
