ECKELMANN AL 300 S, Operating Instruction

Page: 44 / 61

Menu structure of AL 300
39
Version 3-1 05. Dezember 2019
S
Screen 7-2 Status
Select an E*LDS component either by entering its CAN bus address and confirming with the ENTER key or by
using the up and down cursor keys (
↑
) (
↓
). You can switch between the following two screens using the (→)
and (←) cursor buttons.
Page 1 – Show current status of CAN bus stations
STATUS Nd.nnn
Heading and Node No. of E*LDS components Entry
Name of E*LDS component Name of E*LDS component ↑ ↓
→
Item ID XXXXX
→
Item ID of E*LDS component. Move to Page 2 – Software Version
Operating
ALARM IEOF
√
Shut down manually
Component alarmed
Status:
Component operating
Refrigeration point shut down manually
Component alarmed as failed
The bottom line shows the current operating status of the selected E*LDS component. If the component is
working, detailed information on its status is given:
ALARM
A minimum of one fault still exists.
I
Operating archive has been created.
e/E
EU archive has been created / and is active.
O
CAN bus failure
F
CAN bus fault
√
Communication enabled
Page 2 - Software version
STATUS Nd.nnn
Heading and Node No. of E*LDS component Entry
Typ
XXXXXXXXX
Type of E*LDS component ↑ ↓
←
Version X.XX
←
Software Version No.
S.Nr. XXXXXXXXXXXXXXXXXXXXX
Serial No. of component
S
Screen 7-3 Configuration
This screen is used to change station details such as name, ID and alarm priority for every E*LDS component
connected to the CAN bus.
CONFIGURATION Nd. Nd.nnn
Heading and Node No. of E*LDS component
Name of component
→
Name of E*LDS component
Item ID XXXXX
→
Item ID of E*LDS component
Priority p
Alarm priority of E*LDS component
delete
Remove E*LDS component from system:
Delete E*LDS component:
Displays prompt: Are you sure? No: ESC Yes:
↵
A station can only be deleted after it has been shut down and subsequently reported as failed or
manually shut down.