Chapter 3
•
Installing the antenna and radio
1042161-0001 Revision A
21
Before you assemble the antenna, read these important instructions:
•
Sequence of steps
–
When you assemble the antenna,
be sure to follow the
instructions in this chapter in the order they are presented
.
For rooftop installations, assemble the antenna on the ground and then carry
the fully assembled antenna up to the roof.
•
Tightening hardware
–
Do not tighten any nuts or other hardware until
instructed to do so
. See
•
Torque
–
To ensure successful installation of the antenna, it is critical that you
tighten all nuts and socket‐head screws to the torque values shown in
Table 4: Torque specifications
Fastener or connector
Proper torque value
5
16
⁄
inch
15 ft‐lb
1
4
⁄
inch
3 ft‐lb
M4 wrench
19 in-lb
Select the installation site
The first and most important consideration when choosing a prospective site is
whether the site can provide an acceptable line of sight (LOS) to the satellite.
Choose a site where the antenna will be able to receive the strongest signal
available. A clear, unobstructed view of the southern sky is necessary for proper
transmission. Consider obstructions that may occur in the future, such as
construction in the area, or the growth of trees.
Also, consider potential grounding sources when choosing a location. For guidance
on grounding, see the documents listed in
on page 39.
As with any type of construction, a local building permit may be required before
installing the antenna. It is the property owner's responsibility to obtain necessary
permits and comply with local building codes.
Summary of Contents for HUGHES KU-Band
