Milestone AV Technologies and its affi
liated corporations and subsidiaries (collectively, “Milestone”), intend to make
this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all
details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or
use of this product. The information contained in this document is subject to change without notice or obligation of any
kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein.
Milestone assumes no responsibility for accuracy, completeness or suffi
ciency of the information contained in this
document.
©2015 Milestone AV Technologies. All rights reserved. ECHOGEAR is a Milestone brand. ECHOGEAR and the ECHOGEAR
logo are trademarks of Milestone.
Made in China.
Milestone Global Headquarters
• 6436 City West Parkway • Eden Prairie, MN 55344 USA
16 - 24 in.
(406
- 610 mm)
16 - 24 in.
(406
- 610 mm)
3-1
3-2
3-3
3-4
6901-002431 02
Assemble
the wall plate
sections
01
and
02
with the
connection plate
screws
03
.
Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Be sure to drill into the center of the stud.
IMPORTANT
: Pilot holes must be drilled to a depth of 3 in. (75
mm).
06
07
01
02
Check knobs on brackets
04
and
05
to ensure that they are tight
before hanging TV. If you desire a
degree of tilt, loosen the knobs, adjust
the tilt and retighten.
NOTE:
It will be necessary to remove
the TV from the wall plate assembly to
make tilt adjustments.
Unscrew locking screws
[LS]
on brackets
04
and
05
enough to clear the bottom of the wall
plate assembly.
Hang the TV with brackets
04
and
05
onto the
wall plate assembly.
Locate your
stud. Verify
and mark
the center
of the stud
by fi nding the
stud edges using
an awl, a thin
nail, or an edge-
to-edge stud fi nder.
Position
the wall
plate
assembly
at your desired
height and line
up the holes with
your stud center
line. Level the wall plate
and mark the holes.
01
02
[LS]
[LS]
Install the
wall plate
assembly using lag
bolts
06
and washers
07
. Tighten
the lag bolts
06
only until
the washers
07
are pulled firmly against the
wall plate assembly.
Step 3 Wood Stud
Step 4 Tighten Knobs
Step 5 Hang TV
Step 6 Secure TV
Step 2 Assemble Wall Plate
3 in. (75 mm)
7/32 in.
(5.5 mm)
05
05
05
04
04
04
01
02
Tighten the locking screws
[LS]
on
brackets
04
and
05
to secure the
TV to the wall plate assembly.
03
CAUTION:
Avoid potential personal injuries and property damage!
●
Drywall covering the wall must not exceed 5/8 in. (16 mm)
●
Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 1½ x 3½ in. (38 x 89 mm)
CAUTION:
Avoid potential personal injury or property damage! All lag bolts
06
MUST BE firmly tightened to prevent
unwanted movement of the wall plate assembly.
CAUTION:
Ensure the wall plate assembly is securely fastened to the wall before continuing on to the next step.
