4
Important Safety Instructions
WARNING:
ELECTRICAL SHOCK HAZARD
THE OWS USES HIGH VOLTAGE AND SHOULD ONLY BE INSTALLED BY
A QUALIFIED INSTALLER OR ELECTRICIAN. FOLLOW ALL APPLICABLE
ELECTRICAL CODES IN THE COUNTRY OF INSTALLATION.
Installing the OWS
Review these instructions completely before installing the OWS Wall Switch
Sensor.
NOTE: The OWS should only be installed in an indoor location. It must be
mounted in an electrical junction box, preferably non-metallic.
1. Locate the circuit breaker panel and turn off the power to the
circuit.
2.
Remove any face plates from the junction box.
3. Refer to the wiring diagram to connect the OWS to the line
power and ground. Use wire nuts on all connections. The orange antenna
wire should be left in the antenna channel as shipped. Do not cut or cap
the antenna wire.
4. Restore power to the circuit.
5. Before installing the faceplate, the OWS should be linked to a receiver if
not done previously. Refer to the section later in this guide on the linking
process.
6. Install the faceplate (not included). A non-metallic faceplate is highly
recommended.
Wiring Instructions
Power is connected to the Black (120VAC or 277VAC) wire and the Green
(Ground) wire is connected to building ground. The OWS is a no-neutral
conductor design meaning there is no White (Neutral) wire required.
Wire specifications: Min wire size 300V 14 AWG 60° C
Orange
Antenna
Wire.
Do not cut
or cap
Ground connection is required for proper operation and safety. No-neutral design
