Echoflex Installation Guide
ElahoAccess Interface
Note:
When using Category 5 (or equivalent) cable on the EchoConnect
communication bus, please note the following:
•
Cat5 wiring must be terminated using EchoConnect Cat5
Termination Kit and must be installed using a bus topology.
Refer to the installation guide that is provided with the Cat5
Termination Kit (8186A1207) for information to terminate
Cat5 wiring.
•
Not all topologies are supported using Cat5; careful planning
is required to ensure the proper termination kits are available
and the wire is pulled appropriately.
Install the Interface
Receptacle spacers are
provided to help align the
Interface and cover flush
against the wall in flush
mount application. The
spacers are not required
when installing the
Interface in a surface
mounted box.
1.
Insert the Interface electronics and wiring into the back box. To install
multiple Elaho products (multi-gang), insert the Interface electronics
into the back box from the right to the left side for the best alignment
and fit. The alignment bracket will slightly overlap the Interface to the
right when properly installed.
a.
Use spacers as needed to provide a flush mounted Interface.
b.
Fold the spacer in a zig-zag fashion and press the stack together
to achieve the thickness needed to fill the gap between the
Interface, wall surface, and the back box.
c.
Cut off and discard the excess.
d.
Place the stack between the Interface electronics and the flush
mounted back box.
2.
Secure each Interface electronics in place using the two screws
provided. If using spacers, insert the screws through the spacers as
well.
ElahoAccess Interface Installation Guide
Page 5 of 8
Echoflex Solutions, Inc.
