11
Before you start
3.
Thread nylon line cutting head (B) onto shaft (anticlockwise)
until it is tight.
4.
Remove locking tool (C).
U-handle version
U-handle assembly
1.
Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (D) and fix handle by tightening
handle assembling bolt (8 mm) (B) lightly.
2.
Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
C: Washer
E: Arrow
F: To engine
3.
To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
K: Nuts
Installation of shield
1.
Fit bracket (A) to mounting portion of angle transmission and
fix the bracket by holding fitting plate (B) pressed from be-
neath and tighten 4 bolts (M5×25) (C) lightly.
2.
Get notches (D) and convexes of fitting plate (E) to face cor-
responding convexes and concaves of bracket, and fix
bracket tightening 4 bolts (M5×25) securely.
CAUTION
Install the handle so that it does not hide any of the
safety decals.
CAUTION
After assembly, adjust the play of wire end (J) on carbu-
rettor (L) side to 1 mm - 2 mm.
