11
Bevor Sie beginnen
Zusammenbau
Rundgriff-Version
Befestigung des Rundgriffs
Befestigen Sie den Rundgriff (A) und die Halterung (C) am
Antriebswellenrohr.
Richten Sie den Griff in eine für das Arbeiten bequeme Position
aus, und ziehen Sie die Schrauben (B) fest.
Montage des Schutzschilds
1.
Befestigen Sie das Schutzschild (A) am Winkelgetriebe und
ziehen Sie die 4 Schrauben (B) fest.
Wechseln des Schutzschildes
Es gibt zwei unterschiedliche Schutzschilde: der eine
Schutzschild wird ausschließlich zur Verwendung des
Nylonfadenkopfes, der andere ausschließlich zur
Verwendung von Metallmessern angebracht. Wenn Sie mit
Metallmessern arbeiten, verwenden Sie den Schutzschild für
Metallmesser.
1.
Lösen Sie die Schraube (A) auf der rechten Seite der
Halterung (B) komplett, um das Schutzschild verschieben zu
können. Die Schraube selbst kann nicht von der Halterung
entfernt werden.
2.
Drücken Sie die Taste (C), schieben Sie das Schutzschild
(D) nach links und nehmen es ab.
3.
Ein anderes Schutzschild (E) in die Nut einführen und bis
zum Anschlag nach rechts schieben. Die Schraube
unbedingt festziehen.
WARNUNG
Lesen Sie die Bedienungsanleitung aufmerksam durch, um sicherzustellen, dass Sie das Produkt
korrekt zusammenbauen.
Die Verwendung eines falsch zusammengebauten Produkts kann zu Unfällen bzw. schweren Verletzungen
führen.
E: Pfeil
F: Zum Motor
VORSICHT
Montieren Sie den Griff so, dass er die
Sicherheitsaufkleber nicht verdeckt.
Summary of Contents for SRM-236
Page 2: ...2 ...
Page 103: ...33 X772 000891 X772227 6101 2012 1Note e quarta di copertina MEMORANDUM ...
Page 139: ...3 ...