![background image](http://html.mh-extra.com/html/echo/srm-211/srm-211_operators-manual_532771019.webp)
G
RASS
T
RIMMER
/B
RUSH
C
UTTER
O
PERATOR
'
S
M
ANUAL
19
7. Position Lower U-Handle Bracket (K) 400mm (15-3/4 in.) from
engine end of drive shaft. Secure with three (3) 5mm x 30mm
bolts.
8. Install harness hook (included with Blade Conversion Kit) for blade
use. Position 220 mm (8-5/8 in.) from engine end of drive shaft
assembly. DO NOT tighten at this time.
9. Install upper U-Handle and bracket on lower bracket and secure with
one (1) 8mm x 55mm bolt (L) and large circular washer.
10. Secure throttle linkage and leads to drive shaft with cable clips
supplied.
11. Install power head and align gear box, power head and U-handles.
Tighten all screws.
12. Place throttle linkage in slot in bracket with one nut (A) on each side
of bracket. Finger tighten both nuts (A).
13. Attach inner throttle cable to swivel (B). Check throttle for freedom
of movement and that wide open throttle / low idle extremes are
adjusted properly. If adjustment cannot be achieved by adjusting
nuts (A), consult with your Echo Dealer for correct adjustment
procedure.
14. Attach ignition leads (E).
15. Balance unit.
a. Put on harness and attach unit to harness.
b. Slide clamp (M) up or down drive shaft housing until unit
balances with cutting attachment approximately 2 - 3" from
ground.
c. Tighten harness clamp screw.
L
400 mm (15-3/4 in.)
220 mm
(8-5/8 in.)
ENGINE
END
K
M
A
B
E
E