8
C
A
B
A
SSEMBLY
WARNING
DANGER
Do not perform maintenance or assembly procedures with engine
running.
Tools Required: Cross Head Screwdriver, 10 mm Open End Wrench
Parts Required: ProSweep Gear Housing, Lower Drive Shaft
Assembly, PAS or SRM-SB Power Head w/Shaft &
Coupling.
PROSWEEP
GEAR
HOUSING
ASSEMBLY
TO
LOWER
DRIVE
SHAFT
ASSEMBLY
1.
Place brush gear housing assembly on a flat surface with gear
housing shaft mount at 45
°
angle.
2.
Remove gear housing locator screw (A) with cross head screw-
driver.
3.
Loosen (2) two gear housing mounting bolts (B) with 10 mm
wrench.
4.
Position lower drive shaft (end without safety decal) into gear
housing shaft mount.
5.
Align hole in drive shaft housing with gear housing shaft hole (C)
and seat lower drive shaft end into gear housing shaft mount.
Install and tighten locator screw (A).
6.
Tighten gear housing mounting bolts (B).
__ 1 - ProSweep Attachment
__ 1 - Brushes / Gear Housing Assembly
__ 1 - Lower Drive Shaft Assembly
__ 1 - Operators Manual
__ 1 - Warranty Registration Card
__ 1 - Storage Hook Assembly
C
ONTENTS
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
