Echo shindaiwa CS-360WES, Service Data, Page: 3 / 8

SERVICE INFORMATION
CS-360WES
3
1-2 Technical data
Engine
Idling speed r/min 3,200 +/- 400
Wide open throttle speed* r/min 12,500 - 13,100
Clutch engagement speed r/min 4,300
Engagement Minimum
†
r/min 3,900
Compression pressure MPa (kgf/cm
2
) (psi) 0.94 (9.6) (133)
Ignition system with stop holding function
Spark plug gap mm(in) 0.6 - 0.7 (0.024 - 0.028)
Minimum secondary voltage at 1,500 r/min kV 22
Primary coil resistance
M Ω 2.4 -2.9
(Red Probe on stop terminal of module)
Secondary coil resistance Ω 940 - 980
Pole shoe air gaps mm (in) 0.3 - 0.4 (0.012 - 0.016)
Ignition timing at 3,000 r/min °BTDC 19
at 8,000 r/min °BTDC 34
at 10,000 r/min °BTDC 34
Carburettor
Idle adjust screw initial setting turns in** 1 1/8
L mixture needle initial setting turns out 1 1/2
H mixture needle initial setting turns out 2 1/8
Test Pressure, minimum MPa (kgf/cm
2
) (psi) 0.05 (0.5) (7.0)
Metering lever height mm(in) 0.1-0.25 (0.004-0.01) lower than diaphragm seat
Chain oil discharge volume at 7,000 r/min
Fixed 7.0 mL/min
mL/min(U.S. fl .oz./min)
BTDC: Before top dead center.
* With 35 cm guide bar and properly adjusted saw chain.
**Set Idle adjust screw to the point that its tip contacts throttle plate before initial setting.
†
If clutch engagement speed is lower than minimum clutch engagement speed, replace clutch assembly with
new one.