16
Cleaning Cylinder Fins
1.
Remove spark lead and spark plug.
2.
Remove two upper 3 mm hex screws at recoil starter.
3.
Remove engine cover (five screws), pull cover away from engine.
Loosely install spark plug to prevent dirt from entering cylinder.
Clean cylinder fins to allow cooling air to pass freely.
4.
Remove spark plug and loosely reassemble engine cover with five
cross head and two hex head screws.
5.
Tighten all screws securely.
6.
Install spark plug and spark plug lead.
EXHAUST
SYSTEM
Spark Arrestor Screen
Level 2.
Tools required:
Cross Head Screwdriver, 3 mm Hex Wrench, 25-50 mm
(1-2 in.) Cleaning brush
Parts Required: Spark arrestor screen P/N 14586240630,
Gasket P/N 14568842031
IMPORTANT
Carbon deposits in muffler will cause a drop in engine output and
overheating. Spark arrestor screen must be checked periodically.
1.
Remove spark lead and spark plug.
2.
Remove two upper 3 mm hex screws at recoil starter.
3.
Remove five engine cover screws and remove cover from engine.
Clean cylinder fins with brush to allow cooling air to pass freely.
4.
Remove spark arrestor cover (A, B), gasket (C) and spark arrestor
screen (D) from muffler. Replace screen if plugged with carbon
deposits.
5.
Install spark arrestor screen, gaskets, and cover.
6.
Loosely reassemble engine cover with five cross head and two hex
head screws.
7.
Tighten all screws securely.
8.
Install spark plug and spark plug lead.
D
C
B
A