Echo HCAS-2620ES-HD, Operator'S Manual

Page: 29 / 168

27
Maintenance and care
Troubleshooting table
Problem Diagnosis Cause Solution
The engine does
not start  There is no fuel in the fuel tank
 The ignition switch is in the Stop posi-
tion
 Excess fuel suction
 Electrical fault
 Carburettor malfunction or internal
sticking
 Internal engine malfunction
 Fuel supply
 Move to the Start position
 Start the engine after servicing
 Consult your dealer
 Consult your dealer
 Consult your dealer
Engine is difficult to
start, fluctuating ro-
tation Fuel is entering the over-
flow pipe  Fuel degradation
 Carburettor problem
 Replace with new fuel
 Consult your dealer
No fuel is entering the
overflow pipe  Fuel filter is clogged
 Fuel system is clogged
 Internal carburettor parts sticking
 Clean or replace
 Consult your dealer
 Consult your dealer
The spark plug is dirty or
damp  Fuel degradation
 Incorrect electrode gap
 Carbon deposits
 Electrical fault
 Replace
 Replace
 Replace
 Consult your dealer
Engine starts but
no acceleration is
possible  Dirty air filter
 Dirty fuel filter
 Blocked fuel passage
 Carburettor adjustment problem
 Blocked exhaust vent or silencer vent
 Clean or replace
 Clean or replace
 Consult your dealer
 Adjust
 Clean
The engine stops  Carburettor adjustment problem
 Electrical fault
 Adjust
 Consult your dealer
The engine fails to
stop  Ignition switch malfunction  Perform an emergency stop
and consult your dealer
The cutter blades
moves when the
engine is idling  Carburettor adjustment problem
 Damaged clutch spring
 Adjust
 Consult your dealer
The cutter blades
gets blunt  Worn cutter blades
 Big gap between upper blade and low-
er blade
 Slippage of the clutch
 Consult your dealer
 Consult your dealer
 Consult your dealer
 Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
 Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
 For spare parts and consumables, please use only genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a malfunction.
NOTE
"ES" START (See page 2)
When starter handle cannot be pulled lightly, the trouble is diagnosed as failure of engine inside.
Please consult your dealer.
If disassembled inadvertently, it can cause injury.