MAINTENANCE
HCA-2620/S
38
X7502342203
© 08/20 ECHO Incorporated
2.
Pull the drive shaft (C) from the
housing, wipe clean, then apply
15 ml (0.5 oz.) of grease.
3.
Slide the drive shaft back in the
drive housing being careful not
to get dirt on the flex shaft.
4.
Install the gear housing assembly.
Blades
Hedge trimmer blades are very sharp, touching them may lead
to severe personal injury. Use long hex wrenches and sockets
with extensions when tightening blade screws and blade lock
nuts to keep hands at a safe distance from sharp blades.
Blades should only be removed and reinstalled by an authorized
servicing dealer, otherwise premature wear or internal damage may
occur.
Sharpening
Level 2.
If a power grinder is used DO NOT allow blade to over heat.
1.
Move stop switch to STOP
position.
2.
Disconnect spark plug wire.
3.
Remove blade guard.
4.
Slide blades to allow file
clearance using slots (A) on
bottom of blade. Do not pry
against cutting edges.
5.
File each edge carefully. Follow
the original shape of the blade.
6.
Install blade guard.
C
A
