21
Exhaust Port Cleaning
Level 2.
Parts Required:
As needed: Muffler Gasket
1. Remove spark plug lead.
2. Remove muffler cover screws and remove muffler cover.
3. Place piston at top dead center.
4. Remove muffler bolts (A), eyeplate (B), muffler (C), and muffler
gasket (D). Check parts for wear or damage, and replace if neces-
sary.
5. Use a wood or plastic scraping tool to clean deposits from cylinder
exhaust ports (E).
6. Install muffler gasket (D), muffler (C), eyeplate (B), and muffler
bolts (A). Tighten bolts to 60-70 kgf • cm (50-60 in • lbf).
7. Connect spark plug lead.
8. Start engine, and allow unit to warm up
at idle
for several minutes.
9. Stop engine, and re-tighten bolts to to 60-70 kgf • cm (50-60 in •
lbf).
10. Install muffler cover and tighten screws.
11. Start engine and check for exhaust leaks between muffler and cyl
-
inder head. Stop engine if leak is found and correct problem before
operating chain saw.
A
B
C
D
E
Summary of Contents for CS-341
Page 31: ...31 notes ...
