Echo CS-2511T, Owner'S/Operator'S Manual

Page: 9 / 36

9 CS-2511T
1. Operators manual - Included with unit.
Read before operation and keep for future
reference to learn proper, safe operating tech-
niques.
2. Safety manual - Describe operating and safety
instructions for this chain saw.
3. Front hand guard - Guard between the front
handle and the saw chain for protecting the
hand from injuries and aiding in control of the
chain saw if the hand slips off the handle.
This guard is used to lock the chain brake
which is to stop the saw chain rotation.
4. Rear handle (for the right hand) - Support
handle located on the top of the engine hous-
ing.
5. Choke control knob - Device for enriching the
fuel/air mixture in the carburetor to aid cold
starting.
Also activates fast idle throttle latch.
6. Muffler cover - Cover the muffler not to make
operator touch to hot surface of muffler.
7. Chain tension adjuster - Device to adjust chain
tension.
8. Clutch cover - Protective cover to the guide bar,
saw chain, clutch and sprocket when the chain
saw is in use.
9. Chain catcher - A projection designed to reduce
the risk of the operator’s right hand from being
hit by a chain which has broken or derailed
from the guide bar during cutting.
10. Guide bar - The part that supports and guides
the saw chain.
11. Saw chain - Chain, serving as a cutting tool.
12. Bar tip guard - Anti-kickback device attached on
the bar nose.
NOMENCLATURE OF PARTS
13. Front handle (for the left hand) - Support
handle located at the left side of the engine
housing.
14. Fuel tank cap - For closing the fuel tank.
15. Oil tank cap - For closing the oil tank.
16. Starter handle - Pull handle slowly until starter
engages then quickly and firmly.
When engine starts, return handle slowly.
Do not let handle snap back or damage to
unit will occur.
17. Spark plug cover - Covers spark plug.
18. Spark plug cover lutch - Device for installing
the spark plug cover.
19. Cleaner cover lutch - Device for installing the
air cleaner cover.
20. Air cleaner cover - Covers air cleaner.
21. Purge pump - When starting engine, push
purge pump 3 or 4 times.
22. Throttle trigger - Device activated by the
operator’s finger, for controlling the engine
speed.
23. Throttle trigger lockout - A safety lever which
must be depressed before the throttle trigger
can be activated in order to prevent the
accidental operation of the throttle trigger.
24. Ignition switch - Device for connecting and
disconnecting the ignition system and thus
allowing the engine to be started or stopped.
25. Lifting hook - If working off the ground the
operator must be trained in safe climbing
techniques and use of all recommended
safety equipment.