![background image](http://html1.mh-extra.com/html/echo/99944200615/99944200615_operators-manual_4002547011.webp)
PAS R
APid
L
oAdeR
TM
C
uRved
S
hAfT
T
RiMMeR
A
TTAChMenT
o
PeRAToR
'
S
M
AnuAL
11
lubrICaTIon
Level
1.
Parts Required:
POWER BLENDX
TM
8 oz. (P/N 91014) or
Lithium Base Grease.
1. Remove plastic shield.
2. Loosen bearing housing locating screw (A), at the top of the hous-
ing, loosen mounting screw (B) and remove gear case from drive
housing.
3. Pull the flexible drive shaft (C) from the drive housing, wipe clean
and recoat with a thin coating [1/2 oz. (15 ml)] of grease.
4. Slide the flexible drive shaft back in the drive housing being care-
ful not to get dirt on the flexible drive shaft.
5. Install the bearing housing and shield.
A
B
nylon
lIne
replaCemenT
Level
1.
Parts Required:
Pre-cut Nylon Line
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Remove old nylon line through center recess of head.
3. Insert pre-cut 204 mm (8 in.) length of nylon cutting line (recom-
mended sizes 2.4 mm [.095 in.] to 3.9 mm [.155 in.]) through
outside openings of trimmer head. Minimum of 153mm (6 in.) of
line should extend from each opening. 3.9mm [.155 in.] line not
recommended for trimmers under 26cc.
NOTE
Insert cutting line ends to center of head recess to insure easy
removal of used lines.
NOTICE:
Nylon line can damage plastic shield. When installing line seg-
ments, make sure line does not curve upward toward shield.
MODELS
REQUIRED LINE SIZES
SRM-2100SB
SRM-210SB/211SB
PAS-210/211
PAS-225
PAS-230/231
SRM-2400SB
.095 - .130 in.
SRM-260SB/261SB
PAS-2601
PAS-260/261
PAS-265
.080 - .095 in.
.095 - .155 in.
C