5
Clip
Nut
Flange
Nut
28.
Connect the two (2) Ignition Leads between the Control Handle and
engine then slide engine onto Main Pipe assembly.
29. Position Cable Clip under Main Pipe then over Throttle Cable and
Ignitions Leads. Slide clip tangs under T27 screw head then tighten
Main Pipe clamping screw.
30. Install Throttle Cable end into carburetor Swivel. Install Clip in groove
of Swivel to prevent cable end from coming out. Finger tighten Flange
Nut.
31. The engine must always return to idle when Throttle Trigger is re
-
leased. adjust the Throttle Cable to allow .4mm to .6mm of trigger
free play at idle position. Make Throttle Cable adjustments by turning
the Nut on the cable threads either clockwise or counterclockwise.
Check that carburetor rotor moves smoothly from idle to wide open
throttle and back to idle. Tighten Flange Nut when adjustment is com
-
plete.
32. Start engine, and accelerate slowly to verify Flexible Driveshaft
engagement.
Flex cable conversion is complete.