Bus Select (Indigo DJx Only)
To select an output bus, click on either the “Outputs 1-2” tab or the “Outputs
3-4” tab at the top of the Console. (See figure above.) Clicking on an output
bus tab simply selects the settings that are displayed. In the figure above
“Outputs 3-4” is the active bus. This means all parameters such as volume,
pan, and mute apply to the audio coming out Analog Outputs 3 and 4 of your
Indigo DJx.
Master Output Bus Control
The master bus control is the area on the right side of the Console. The
figure above shows the Indigo DJx Console. The Master Output bus is
labeled “Analog: Out 3 – Out 4.” This indicates you are currently
controlling everything mixed to analog outputs 3 and 4. The Indigo IOx only
has controls for Analog Outputs 1 and 2.
The
mute buttons
and
faders
affect everything being mixed to this bus.
Holding down the Ctrl key and clicking on a fader will set that fader to 0 dB,
and clicking on the readout below the fader will allow you to enter a
numerical value for the fader setting. You can also select or deselect all the
mute buttons by Ctrl-clicking on one of them.
The
gang button
, below the fader readout, sets the gang mode. If you are in
gang mode, the mute buttons will work together for the left and right
channels; for example, clicking the mute on one channel activates the mute
button on the other channel. In addition, ganging ties the faders together so
they will maintain their relative placement with regard to each other.
18
