EN
30
31
DESCRIPTION
1
2
3
4
5
6
1. Hot air vent
2.
TURBO
button with indicator
3. ON/OFF button
4. Temperature control
5. Timer
6. Air inlet
USINg THE APPLIANCE
This convector uses hot air technology with temperature regulation. It is also equipped with the
Turbo
function. Temperature control regulates the temperature of the convector. Turn the power control to set the
required level: You may also use the Turbo button to heat the room faster.
3 power levels can be set using the ON/OFF buttons
1 = power of 750 W
2 = power of 1250 W
1+2 = power of 2000 W
The device shall only be handled when turned off via the main switch and disconnected from the network
outlet.
TIMER
The convector is equipped with an interval 24 hour timer.
Turn the dial to the right to set the current time by the arrow symbol.
The dial is divided into 96 segments. Each segment represents 15 minutes. The timer switches ON or OFF
every 15 minutes according to whether the segment is active (pulled out) or inactive (pushed in).
The timer is equipped with a three-position slide switch ( ).
The middle position ( ) of the timer switches the heater on or off according to the position of segments (see
Setting the timer below).
The “ ” position switches the heating on permanently. The timer remains active but does not effect heating
operation. You must switch the heating off by changing the slide switch to “ ”. In this position, the appliance
is not powered but the timer remains active without affecting the heating operation.
