GB
37
The surfaces marked in this way become hot during use.
DO NOT COVER!
WARNING
Some parts of this product may become very hot and cause burns. Pay special
attention in the presence of children and handicapped persons.
INSTALLATION
The base must be attached to the convector before first use.
Prior to any manipulation with the device always disconnect the power supply to prevent injury by electric
shock.
Make sure that the package contains beside the body of the convector all other parts necessary for assembly.
Contact your vendor if this is not the case.
Package contents:
Hot air convector
Set of bases mounts with wheels:
2x base with wheels
2x screws to attach the bases
Operating manual
Base assembly
1. Turn the convector upside down.
2.
Place the two bases on the underside of the convector so that the pins on the
base fit into the holes in the convector and attach using the screws.
3.
Turn the convector back into a normal operating position after the assembly
and check if the convector is stable.
USING THE APPLIANCE
Note:
After transportation or storage under cold conditions it is necessary to allow the appliance to acclimate
at least 2 hours at room temperature.
Note:
An odour or smoke may emit from the heat elements during the first use of the appliance or when
turning on after a longer period of time. This effect is normal and will go away after a short while.
Thermostat controller (
A
) is used to regulate temperature. Turn the power control to set the required level:
You can set 2 power levels with the on/off and power level switch:
2 power levels:
0
= off
I
= 750 W
II
= 1500 W
