GB
24
QUICK SETUP
Step 1: By sliding remove the battery compartment cover in the back of the device and insert two AA
batteries. Carefully o/- polarity. Put on the battery compartment cover back. Now the device is ready
to operate.
Step 2: The device begins to search wireless outdoor temperature sensor´s signal within fi rst 3 minutes before
DCF signal searching. If the device did not fi nd any DCF signal in day, set the clock manually.
DEVICE LOCATING OR HANGING
To install the device on a table, set the holder on the device´s back; to install it on a wall, set the holder on the
device´s rear. The longer and thinner holder´s side should be set on its rear or upper face.
Humidity level can signifi cantly change according to the device´s location. Therefore install it in such a way
as to work under appropriate conditions.
This thin side upwards
This thin side
backwards
DCF SIGNAL RECEPTION AND INDICATION
After turn on the device begins to receive DCF signal. icon fl ashes.
DCF signal reception
( icon fl ashes)
Suffi
cient reception
( icon lights)
Poor reception
( icon disappears)
If the clock does not receive any DCF signal it begins to reach it later.
If DCF signal failure occurs the device selects the same frequency during next reception.
Automatic and manual reception
The clock begins to receive a signal every day at 01:00, 02:00, and 03:00. If no DCF time signal is received at
03:00 reception is run also at 04:00. If this attempt fails new reception is run at 05:00. If no signal is received
automatic information reception begins at 01:00 next day again.
Manual reception: By holding
WAVE
/
V
button, manual reception is run. To stop DCF signal reception, hold
WAVE
/
V
button for 2 seconds.
While receiving RCC
SET
,
ALM SET
,
UP
,
DOWN
,
ALM ON-OFF
buttons are not available and no temperature
and humidity measurement is active. Temperature and humidity values settle down and stay precise after
approx. 30 minutes since turning on.
SET UP DIARY, 12/24 H TIME INDICATION
1. Hold
SET / ALM SET
button for 2 seconds, time fi gures change into “2008 YR” and fl ash. To set year, press
v
/
V
button.
2. Then
press
SET / ALM SET
button again; month fi gures fl ash. To set month, press
v
/
V
button.
3. After next pressing
SET / ALM SET
button, date fi gures fl ash. To set day, press
v
/
V
button.
Summary of Contents for MS 002
Page 2: ......
