20
EN
INSTALLATION
1. Unscrew the nut that attaches the back screen by turning it
counter-clockwise
.
2. Place the back screen opposite of the front motor cover with the handle facing upward. Make sure the
guide pins of the motor cover are properly inserted into the screen holes.
3. Screw the nut for attaching the back screen fi rmly to the motor by turning it
clockwise
.
4. Remove the plastic protector from the shaft.
5. Place the propeller on the motor shaft by carefully sliding it onto the guide pin of the motor shaft.
6. Screw the nut for attaching the propeller to the motor shaft by rotating it
counter-clockwise
and
tighten fi rmly.
7.
Attach the front screen to the back screen. Insert the screws in the holes of the ring and screw nuts on to
these. Do not tighten the nuts completely at this time.
8. Move the screen pins so they fall into place.
9. Finally, tighten the small screws fi rmly.
1. Front
guard
2. Fan
blade
3. Guard mounting nut
4. Rear
guard
5. Motor
shaft
6. Motor
housing
7. Oscilation
knob
8. Motor
9. Neck piece assembly
10. Stand
11. Power
cord
12. Speed control switch (0, 1, 2)
Note:
You may register radio interference while switching fan speeds, this eff ect is normal for this kind of
product.
HEAT PROTECTION
Heat protection is activated if an actuating unit is overloaded. The fan switches off automatically. In this case,
refer to a professional service centre.
USE
The fan has 2 speeds, its rotating head ensures smooth rotation. It is quiet, with a low energy consumption,
reliable and safe and at the same time, ensures eff ective air circulation.
0 - Fan is off .
1 - Fan is running at low speed.
2 - Fan is running at high speed.
•
The fan can rotate during operation.
•
For the fan head to rotate, push the automatic rotation control down.
•
To stop the rotation of the fan head, pull the automatic rotation control up.
•
The fan head can be set up or down. Loosen the vertical setting nut, adjust the desired angle of the fan
and tighten the nut again.