English
English
20
Open the bottom cover
Rotate the emergency drain
hose by 90° and pull it out, then
remove its cover
After the water has
drained, insert the
drain hose
Open the filter by
turning it to the right
Collect the sticking
material
Close the bottom cover
Warning:
•
Make sure that the valve cap and emergency drain hose are properly installed, the cap plates should be
inserted aligned with the holes, otherwise water may leak out.
•
Some appliances do not have an emergency drain hose, so step 2 and step 3 can be skipped. Rotate the
bottom cover directly to allow water to flow into the tank.
•
When the appliance is in use and depending on the selected program, there may be hot water in the
pump. Never remove the pump cover during a wash cycle, always wait until the appliance has completed
the cycle and it is empty. When replacing the cover, make sure that it is securely tightened again.
TROUBLESHOOTING
Description
Cause
Solution
The washing machine
does not turn on
The door is not closed
Try again after closing the door. Check that
the laundry is not stuck there.
The door does not
open
The protective circuits of the washing
machine are working
Disconnect the power supply, restart the
washing machine
Water leakage
Inlet valve connection
and the supply hose or drain hose is
not tight
Check and tighten the supply hose. Clean
the drain hose
There are detergent
residues in the
dispenser
The detergent is damp or lumpy
Clean and wipe the dispenser
The lights or display
do not light up
The power supply to the
electronics board or wire harness is
disconnected
Check that the power is not disconnected
and that the power plug is connected
properly
Summary of Contents for EWFS 1063 DE
Page 2: ......