![background image](http://html1.mh-extra.com/html/ecg/cd-190-bt/cd-190-bt_instruction-manual_530942121.webp)
121
EN
SETTINGS
Allows the user to update settings.
AUX
Starting the AUX IN feature of the car stereo (playback from an external AUX input).
COMPASS
Displays the direction while driving.
USB
Playing tracks from the USB device connected to the car stereo.
SD CARD
Playing tracks stored on the SD card inserted into the car stereo.
TROUBLESHOOTING
Before bringing the device to the repair centre, please check the cable wiring. Should problems continue even
after applying the recommendations shown in this table, refer to the nearest authorized service centre.
No power. No sound.
•
The ignition switch of your car is not on. Switch on.
•
Incorrect cable wiring. Check the cable wiring.
•
Blown fuse. Replace fuse.
•
The volume is set to minimum. Set the volume to the desired level.
•
If the instructions above do not help, press the RESET button.
Radio reception noise.
•
The signal is weak. Tune the radio to another station with a stronger signal.
•
Check the antenna connection.
•
Switch from stereo reception to mono.
Preset stations lost.
•
The continuous power cable is not properly connected.
USB device or SD card will not load even after two minutes.
•
Incorrect data on USB/SD.
•
Communication error or damaged device.
TECHNICAL SPECIFICATIONS
General
Power
12 V DC, negative ground
Lid latch
15 A
Acceptable speaker impedance
4–8 Ω
Maximum output power
4× 40 W
Output Pre-AMP voltage
2.0 V (USB playback; 1 kHz, 0 dB, 10 kΩ)
Aux-In
≥ 300 mV
Radio receiver
FM
Frequency range
87.5 to 108 MHz (Europe)
(Tuning step 100 kHz for automatic and manual tuning mode)
Eff ective sensitivity
Better than 15 dB (signal-to-noise = 30 dB)