ECG 40 LED 722 PVR, Instruction Manual

Page: 50 / 72

50
GB
INTRODUCTION
Thank you for purchasing this television product. In order to use this device to its full potential from the very
start, read this manual carefully and keep handy for future use.
ATTENTION
Do not tamper with any internal device components and do not perform any adjustments that are not defi ned
in this manual. LED TVs use high voltage. When cleaning dust or drops off the display or device case, you
should fi rst unplug the power cord from the socket and then wipe the device with a dry towel. To prevent
damaging the TV, disconnect the power cord and antenna during a thunderstorm. Refer to a qualifi ed service
centre for all necessary repairs.
TV INSTALLATION AND SETUP
Instructions for assembling the stand
1. Open the cardboard box and remove the TV, accessories and
stand (only available with certain models).
2. Place the device on a fl at service with the screen facing down.
Use a blanket or other soft fabric to protect the display.
3. Slide the stand into the holder and fi rmly tighten with the
included screws.
4. You are now fi nished with the assembly.
Positioning
• Place the unit within the room so that the display is not exposed
to direct sunlight.
• Complete darkness or refl ections on the screen can cause eye
fatigue. Soft indirect light is recommended for comfortable
viewing.
• Leave enough space between the device and wall to allow suffi cient
air circulation.
• Stay away from excessively warm areas to prevent damaging the
case of the device or the premature ageing of components.
• Do not cover ventilation holes.
Antenna and power connection
1. Connect the antenna cable to the antenna connector on the back side
of the TV.
2. Plug the power cord into the electric socket.
3. Switch the TV on.
Press the On/Off switch on the TV. The indicator will turn green. When
the TV is in standby mode (red indicator), the TV can be turned on by
pressing a button on the remote controller.