Page 2 of 14
Permanent Mounting
1. Determine the location of the lightbar, and the best route for the wiring. Install on the structural part of the roof or surface that has the
least amount of flex.
2. Determine the position of the mounting feet and drill the 5/16”-11/32” diameter mounting holes accordingly, if needed.
The spacing of the mounting feet from left to right is adjustable. It is suggested that the positioning of the feet be symmetrical and near
the curved edges of the roof where the roof is strongest. Ideally, the outermost holes on the feet should be used for installation.
3. Mount the lightbar, with the bolts going through the holes drilled in step 2, routing the wire as planned in step 1 (refer to diagram). See
the Wiring section of this manual for further wiring instructions. Install washers and nuts and secure the unit.
MOUNTING SURFACE
(CUT OUT)
LIGHTBAR
LOAD WASHER
5/16” NYLOCK NUT
5/16” COACH BOLT
7.86”
5.31”
Caution:
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle upholstery, vehicle
support members, etc. that could be damaged.
!
