Page 8 of 11
MENU OPTION: PLAY
RECORDING PLAYBACK
Using the monitor:
1. Press S to enter the single image mode to be adjusted.
2. Press M to enter the Menu
3. Use the + or - to highlight the PLAY Option
4. Press the down arrow to enter the PLAY Option
5. Use the + or - to highlight the desired folder labeled by the dates. (See below)
6. Press the down arrow to enter the folder.
7. Use the + or - to highlight the desired recording labeled by the time and image
channel. (See below)
8. Press the down arrow to play the recording
9. Press M twice to return to the main screen
Using the remote:
1. Press SEL to enter the single image mode to be adjusted
2. Press MENU to enter the Menu
3. Use the < or > to highlight the PLAY Option
4. Press OK to enter PLAY Option.
5. Use the < or > to highlight the desired recording labeled by the time and image
channel. (See below)
6. Press OK to enter the folder
7. Use the < or > to highlight the desired recording labeled by the time and image
channel. (See below)
8. Press OK to play the recording
9. Press MENU twice to return to the main screen
See Record section for setting up a passcode. In order to access the menu after initial setup, you will need the passcode.
Verify Media Player has most up to
date software if given a system error
on playback.
MONITOR MODEL EC7008-WM
INSTALLATION AND MOUNTING:
WARNING!
To prevent accidental shock, DO NOT OPEN THE MONITOR CASE. Opening the monitor case will expose the inside of the monitor to conditions
that could adversely affect performance. Any evidence of tampering with sealed components will void the warranty.
Important!
Do not expose the monitor to water, it is not waterproof. Any water that leaks into the monitor could cause extensive damage.
!
Carefully remove the unit from its packaging. Examine the unit for transit damage. If damage is found, return the product to your local dealer for war-
ranty replacement. Do not use damaged or broken parts.
U-Bracket Monitor Mounting Instructions
1. Select a level surface for installation.
2. Drill mounting holes using the lower U-bracket as a template and attach the U-bracket with user supplied hardware.
3. Install the monitor on the U-bracket as shown in Figure 2. Adjust the monitor’s position for the best viewing angle before tightening the two screws
on each end.
4. Attach the sun-visor as shown. Attach the antennas so they point upward as shown in Figure 3.
