Caution:
When drilling into any vehicle surface,
make sure that the area is free from any electrical wires, fuel
lines, vehicle upholstery, etc. that could be damaged.
Specifications:
Size:
EB7930: 6.0” dia. x 4.8” high
EB7935: 6.0” dia. x 6.8” high
Weight:
approx. 3 lbs.
Input Voltage: 12-48 VDC system
Input Current:
1.3A @ 12.8 VDC
Maximum power consumption: 16 Watts
Temp. Range:
-30°C to +50°C
Installation & Mounting:
Carefully remove the beacon and place it on a flat surface. Examine
the unit for transit damage, and locate all parts. If damage is found,
or parts are missing, contact the transit company or ECCO. Do not
use damaged or broken parts.
Permanent Mounting:
Select the desired location on a flat surface for the LED beacon to be
mounted. The visibility of the flash and ease of wiring access should
be taken into consideration in the selection of the mounting location.
1. Using the base gasket as a template, mark the three mounting
hole locations (see Figure 1).
2. Drill the holes using a 7/32” drill size.
3. A fourth hole may be drilled for wire access as shown in Figure
1, or the wires may be routed through the slot in the base for
external access.
4. Connect the power wires as shown in the wiring section (see
Figure 2).
5. Mount the beacon with #10 hardware.
Pipe Mounting:
The EB7930 & EB7935 series base comes with 1” NPT threads for
pipe mounting.
Figure 1
920-0338-00 Rev. D
Page 2 of 4
Important!
This unit is a safety device, and it must be
connected to its own seperate, fused power point to as
-
sure its continued operation should any other electrical
accessory fail.
!
WARNING!
Failure to follow these instructions can result in fire or injury from excessive heat build up.
Operator is responsible for ensuring cigarette adapter fits correctly into cigarette/auxillary outlet used.
For proper operation, verify cigarette/auxillary outlet circuit is rated to supply, a minimum of 10 amps. (See specifications
section for rated current in amperes).
Do not exceed the current rating for the cigarette lighter power outlet recommended by vehicle manufacturer.
Keep cigarette lighter adapter, and outlet, clean and free of debris.
Do not use the cigarette lighter adapter when wet.
Insert cigarette lighter adapter fully into the outlet for proper connection.
Grasp cigarette lighter adapter, NOT cord, to remove from outlet.
Remove cigarette lighter adapter completely from outlet when light is not in use.
