The unit is designed for electrical systems from 12 to 80 VDC (9 to 86 VDC
extremes). The wiring for all systems is:
Red Wire Positive (+)
Black Wire Negative (-)
All wiring should be a minimum of 18 AWG. A 3-amp fuse in the positive line is
required (see Figure 1). A switch may be used to control the on/off function of
the LED beacon. Note: For model 6263, wires will come from bottom, not side as
Figure 1 shows. Still follow same wiring instructions.
1. Most LED beacon failures, including intermittent or erratic operation as well
as failure of operation can be traced to wiring or battery problems. Check
all wiring, connections, fuse, switch, and battery voltage to insure that the
correct voltage is reaching the LED beacon.
2. If this has not remedied the problem, return product to your local dealer for
warranty replacement, or call ECCO
Customer Service for assistance.
Wiring Instructions:
Maintenance & Troubleshooting:
NOTE: THIS UNIT IS REVERSE POLARITY PROTECTED
AND WILL NOT OPERATE IF WIRED BACKWARD.
Description
Part Number
Lens, 4”
R6260LX*
Lens Gasket
R6220GL
Branch Guard
A6200BG
*where X indicates color: A = Amber, B = Blue, C = Clear, G = Green,
R = Red
Replacement Parts & Accessories:
Figure 1
NOTE: Operating the vehicle without the outer lens installed on the product may result in damage that will NOT be covered under warranty.
!
CAUTION: HIGH VOLTAGE.
Before servicing light, turn
“OFF” power and wait five minutes.
Learn more about emergency and warning lighting on our website.
