Figure 1
Figure 2
IMPORTANT: Before assembling this product, study the parts list and Figure 1.
PARTS LIST
(a) Lower leg tube section (with
feet) x4
(b) Uppper leg tube section x4
(c) Fixing screws x8
(d) Moulded plastic seat x1
(e) Removable table tray x1
(f) Two piece safety harness x1
2. Feed each assembled leg (A-B)
into the four corner leg sockets
underneath the moulded plastic
seat (d) and secure with 4x screws
(c) supplied. (figure 2)
1. Insert lower leg (a) with reduced
diameter into each of the upper
legs (b) with 4x screws (c) supplied.
(figure 2)
Lower legs (a)
Top end reduced
in diameter.
Uppper legs (b)
Fixing screws (c)
(image not to scale)
(image not to scale)
Moulded plastic seat (d)
Removable table tray (e)
(a)
(b)
(c)
(b)
(d)
(b)
(b)
(a)
(a)
(a)
Two piece safety harness (f)
Figure 2
Figure 4
Figure 5
Figure 3
(e)
(d)
Rear hooks into
slots
Front snap-in hooks
3. Stand chair upright and fit the two hooks at the rear of the table tray (e) into corresponding slots in the rear
upper surface of the moulded seat (d).
Lower the tray (e) until the front hooks snap into locking position. (figures 3,4,5)
4. To remove tray (e) unclip front hooks, while lifting front of tray upwards until in a vertical position then lift
out of rear slots. (figures 3,4,5)
