© Copyright – ECB Pty Ltd – 2018
2
13. Connect all winch wiring. Ensure wiring is clear of winch wire rope and routed in such a manner to avoid damage
from heat and or sharp edges. Use four 200mm long zip ties (supplied).
NOTE:
Use 3mm clip lock trim on grille support to protect winch cables.
See figure 12.
14. Position control box on top of winch.
See figure 13.
15. Splice ECB indicator/park light wiring into original wiring loome. Use cable locks (supplied).
16. Attach infill trim (supplied) to top sides of ECB protection bar. Attach 1000mm of 6mm clip lock trim (supplied)
to centre of protection bar. Attach 3mm clip lock trim (supplied) to skirt.
NOTE:
On infill trim, trim 30mm off
lower edge so trim will sit over end of protection bar.
See figures 14, 15 and 16. Trim excess off end to follow
protection bar. See figure 18. NOTE:
Seal any exposed edges of trim with silicone or similar to avoid corrosion
of inner steel.
17. Fit ECB LED indicator / park lights (supplied) into protection bar as per instructions supplied with the LED
indicator kit.
NOTE:
Ensure park light is to outside. See figure 19.
18. Attach ECB fog lights to protection bar. Place M6 x 20 bolts, spring washers (supplied) through light mount from
inside and attach nut to top. Slide assembly into light mount in Protection bar and centralize light to
hole.
TIGHTEN FIRM ONLY.
Fit ECB fog light trims (supplied) to protection bar.
NOTE:
Wider part of trim
faces to centre.
See figure 20.
19. Remove air vents from protection bar to allow access for bolts and nuts.
20. Attach protection bar to inside of steel mounting brackets. Attach control box bracket to protection bar as
installing. Use ¼ x 1 bolt, nylock nut and washer (supplied).
NOTE:
Feed ¼ x 1 bolt from underside. Align control box with cut out in protection bar and
TIGHTEN
bolts and
nuts.
See figure 21.
21. Slide protection bar further in to mount hole positions. Use ½ x 1 ½ bolts, nuts and washers (supplied).
NOTE
: For lower front hole on drivers’ side place spring washer on bolt head with flat washer (this will space bolt
off winch motor).
CHECK CLEARANCE
.
22 Align protection bar with approximately 3-5mm clearance off grille and infill trim just contacting headlights.
See
figures 22, 23 and 24.
23.
TIGHTEN ALL BOLTS/NUTS.
24. Trim plastic inner guard,
See figure 25
, and fold around steel inner panel and over stud. Use 6mm (10mm head)
nut previously removed with ¼ flat washer (supplied)
. See figure 26
.
25. Connect ECB indicator/park light. Secure to original wiring with zip ties (supplied). Ensure wiring is routed in
such a manner to avoid any sharp edges etc.
26. Connect ECB fog lights check operation.
27. Aim ECB fog lamps at low beam height.
TIGHTEN IN POSITION.
28. Refit air vents to protection bar.
NOTE:
Two lower air vents must be trimmed down to avoid fouling on winch
mounting bracket.
