Chengdu Ebyte Electronic Technology Co.,Ltd.
E28-2G4T27SX User Manual
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co., Ltd.
8
5.2. Broadcast
5.3. Broadcast Address
i.e.: set the address of module A as 0xFFFF or 0x0000 and channel as 0x04.
When set A as transmitter (same mode, transparent transmission on), all modules with channel 0x04 will receive broadcast
data.
5.4. Monitor Address
i.,e.: set the address of module A as 0xFFFF or 0x0000 and channel as 0x04.
When set A as receiver, it will receive the data transmitted by modules with channel 0x04.
5.5. Module Reset
When the module is powered on, the AUX output will go to a low level immediately, the module conducts hardware
self-check and sets the operating mode on the basis of the user parameters (M0 M1). During the process, the AUX level
remains low. After the process completed, the AUX outputs high a level and starts to work as per the operating mode
indicated by the combined state of M1 and M0. The user needs to wait until the AUX rising edge is high, indicating the
module is ready for normal work.
5.6. AUX Description
AUX Pin can be used as indication for wireless send & receive buffer and self-check. It can indicate whether there is data
that is yet to send via wireless or whether all wireless data has been sent through UART, or whether the module is still in the
process of self-check initialization.
5.6.1 Indication of serial output
Used to wake up the external MCU (note: AUX indicates no delay under continuous mode)
