PL
SP-PROG_short_manual_v2.1_EN_PL_RU_ES.doc
1.
Connecting device to the programmer.
To configure or monitor the status of the device using the SP-PROG
programmer, connect them to the appropriate socket showed in the
table below.
Socket
Device
CONFIG PXN,LX
(NEW)
PX100N, PX200N, PX100D, LX10,
LX20, LX20G, LX20G-3C, EX20, AG2*,
AG3*, AT*
CONFIG EX,PX
(OLD)
EX200A, PX100A, PX200A
CONFIG CPX,GD
CPX200N, CPX200NW, LX2N, GD30,
GD30.2
2.
Connecting programmer to the computer.
Connect SP-PROG programmer to the PC using RS232 serial COM
port - 1 or the USB port.
3.
Programming the device.
To enter the programming mode (configuration), set the switches on
the housing SP-PROG programmer as follows:
Switch
Position
DEVICE WORK MODE
PROGRAMMING
SIGNAL SELECTION
DATA / PROG
FLOW CONTROL
NONE
USB / RS232 MODE
PROG. USB
4.
Monitoring the device.
To enter the monitor mode, set the switches as follows:
* when monitoring device GD30 switch to position DATA/PROG
Switch
Position
DEVICE WORK MODE
MONITOR / DATA
SIGNAL SELECTION
MONITOR *
FLOW CONTROL
NONE
USB / RS232 MODE
PROG. USB
EBS Sp. z o. o.
59 Bronislawa Czecha St.
04-555 Warsaw, POLAND
Technical support :
+48 22 51 88 477
E-mail :
Webpage :
www.ebs.p
Quick start guide SP-PROG programmer
