USERS MANUAL
EBS MAGNI 500
w w w . e b s s w e d e n . c o m
w w w . e b s s w e d e n . c o m
EBS MAGNI 500 – REAR PANEL FEATURES
1
9
10
3
4
5
6
7
8
2
1. BALANCED OUTPUT
-A balanced output
functions as a high quality line box for
connecting to PA mixing consoles or to
studio or broadcast recording units, with
high noise immunity. The volume level does
not effect this output.
2. GND LIFT SWITCH
-Lifting ground is a great
aid in many occasions eliminating ground
noise and hum. When required, set this
switch to Lift position to disconnect the
ground from the balanced output.
3. PRE/POST EQ SWITCH
-The switch selects the
signal source. In the inner position this
switch selects the overall sound included
settings on the EQ, otherwise, in the lower
position an uncolored sound is taken
immediately after the amplifiers input.
4. EFFECTS LOOP
– This is a serial effects loop
for the use of external units such as box or
rack effects. Nominal level is set for use
with standard stomp boxes.
The loop puts the external effects after the
filter, compressor and drive sections.
5. LINE OUT
-This is a fullrange output that will
drive multiple poweramps, extending the
power of the system. The signal present at
this output is taken after the volume control.
6. PHONES
- 1/4” stereo contact to connect
a pair of standard headphones.
7. SPEAKER OUTPUT
– Option to connect an
extra speaker here. The impedance must
not be lower than 8 ohms.
Warning: Lower impedance than 8 ohms may cause
permanent damage to the amp.
8. MAINS SELECTOR SWITCH
-Selects the
operating mains voltage. Unplug the amp
before selecting the mains voltage!
9. MAINS
– Connect only to the indicated
mains AC voltage and replace fuse if
needed only with same type and value.
10. POWER
-Switches the amp on or off.