20080908#3.0
EBS Ink-Jet Systeme
EN
9
EN
it is in the ON state, the printer receives
and transmits high-frequency (HF) signals.
The controller of the Ink-Jet printer system
controls energy emitted during printer
operation on an on-going basis.
The HANDJET
®
EBS
250 printer
complies with all the requirements of
the regulations concerning the impact
of the HF energy on humans in your
country.
2. Printer
accessories.
If you do not use original EBS parts or
printer accessories, including batter-
ies or electronic components, the
statutory requirements may not be
met and the HF electromagnetic
emission limits may be exceeded.
Medical equipment
Pacemaker
Pacemaker manufacturers recom-
mend that the distance between a
transmitter and the pacemaker be at
least 15 cm so that any mutual inter-
ference between the two devices is
avoided.
Other medical equipment
If you use a piece of medical equip-
ment, please ask the equipment
manufacturer whether the equipment
is sufficiently shielded against elec-
tromagnetic radiation. In certain cir-
cumstances your doctor may help you
gain the information you require.
Operation in explosion hazard
areas
If you work in an explosion hazard
area, switch your Ink-Jet printer off,
do not
replace the batteries or
do not
remove them from the printer and
follow all instructions and precautions.
Sparking generated by batteries may
cause an explosion and/or fire in this
hazardous area and result in personal
injuries or even death.
The regions where a potential explo-
sion hazard exists are usually marked
appropriately. The examples of such
regions are: solvent storage areas,
fuel storage areas and petrol stations,
below-decks onboard ships, storage
areas for explosive gases, air mix-
tures, chemicals and metal or flour
powders.
Operation in areas of blasting
In order to avoid interference during
blasting (shot firing) the printer should
be switched off in blasting areas or in
places where the use of radio devices
is prohibited.
Follow the operating instructions and
information signs.
Confirmity marking
The HANDJET
®
EBS 250 printer has
been subjected to conformity as-
sessment procedure which resulted in
the issue of Declaration of Confor-
mity. This forms the basis for the
statement that the HANDJET
®
EBS 250 printer and the manufac-
turer’s accessories to which this Dec-
laration also relates are in compliance
with the requirements of the following
European Community Directives and
subsequent amendments to these
Directives:
89/336/EEC
,
91/263/EEC
,
92/31/EEC
,
93/68/EEC
,
1999/5/EC
.
and that they meet the following
norms that are harmonised with the
above Directives
EN 61000-6-2:2001,
EN 61000-6-4:2001,
EN 300 220-1 V1.3.1,
EN 300 220-3 V1.1.1,
EN 301 489-1 V1.5.1,
EN 301 489-3 V1.4.1,
EN 60950-1:2001,
