EBS HandJet 250, Operating Instructions Manual

Page: 12 / 34

12
EN EBS Ink-Jet Systeme
20080908#3.0
EN
1
3
2
full ink
container
empty ink
container
Replacing the Ink Container
!
If possible, replace the container
in dustfree conditions so as to
minimise the amount of
contaminants getting in to the
printer’s ink system.
Do not leave the printer with the
ink container detached for a
longer time than that required to
replace the container. While
detaching or installing the con-
tainer be careful not to splash
anyone or anything with ink.
1. Turn the printer off - see
Switching the Printer Off
.
b
a
10
12
2. Put the printer in such a way that
the container points downwards,
turn empty container
10 to the left
(a) so that arrow 12 points to the
OPEN position. Wait about 3
seconds while holding the con-
tainer to equalize the pressure.
3. Remove the container carefully
(b).
See figure
E
.
4. If gasket 32 and contact plates in
the guide holes for bayonets are
dirty, remove ink leftovers from
them with wash-up.
5. Install a new container - see
Installing the Ink Container in the
Printer
.
Switching the Printer On and
Off
See figure
A
.
Switching the Printer On
Press key 18 ,
PRINT
ON/OFF
, and while hold-
ing it down press release button 5 .
When the printer is switched on, lamp
16 glows and a sound signal is heard
from buzzer 33 .
Once the printer has been switched
on, you can start printing a text that is
stored in the printer memory - see
Printing
.
Switching the Printer Off
Press key 19 ,
F 3 sec.
, and release
button 5 at the same time and keep
them down for a few seconds until all
lamps stop glowing after buzzing
33
has been heard.
Installing and Starting the
Printer Control Program
Installing the Control Program
1. Insert the CD supplied along with
the printer to the CDROM drive in
your computer and wait for the
program to start.
!
If the programs on the CD do not
start running on the computer
automatically, start
setup.exe
from the CD’s main directory.