EBS EBS 2600, User Manual

Page: 33 / 184

33 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
Drip molding/sealing cover
The face of the printhead must be secured with an appropriately selected slide during printing.
For the time required to carry out selected service/maintenance procedures, the slide should be
removed and replaced with:
– standard sealing cover 5a (one‑sided item; see Fig. 23 ),
Fig. 23.
5a
or
– a double-sided accessory* (see Fig. 24 ), which is used as
sealing cover 5b or drip molding 5c , depending on the di -
rection in which it is installed on the printhead.
* The double‑sided accessory (Part No. P513324 )
is not supplied with the printer.
For information about customized accesso -
ries contact an authorized representative of
EBS Ink Jet Systeme GmbH .
5b 5c
Fig. 24.
A sealing cover, either standard ( 5a ) or optional ( 5b ) should be used:
– if the printer is to remain unused for at least 1 week,
– each time idle time or downtime occurs if the printer operates in an environment where dirt or
contamination could deposit on printhead nozzles,
– if it is to be transported.
For more details see “8.3.1.1. Installing a Sealing Cover” .
Optional drip molding 5c should be used while the short or long purging/venting procedures are
conducted in the printhead.
For more details see “8.1. Purging/Venting the Printhead” .